SmokerBuilder.com

Any more ideas on how to fix door if already welded on

I cant get doors off. Welded hinges opposite so they would not come off. What should i do if they are already on smikee

Please explain more killswitch. Hows floorjack and chain work

Just got this 22.5 wsm. Always wanted one. Cant wait to try it out. Does anybody else have one

Also the doors dont fit tight the last two inches on bottom of door. Should i heat. Dont wont to warp door. Would really prefer not to heat. Any suggestions

How much space should there be between end of baffle plate and end of tank. The tank has a bell on the end

Need some help with a few things. Any help would be appreciated

Here is pic of the piece of metal I just got from scrap yard. 28"x48" it is 1/4 thick. This piece was $40. Trying to keep cost down by buying leftovers. When I get this smoker done everything in it will come from scrap. I think half the fun in building this smoker is trying to make odd pieces work.

No it hasn't warped yet. I just have it tacked right now. Not going to weld it good until I have one end on. I think that will help. I was wrong the two side pieces are a heavy 5/16

I have some spare time at work so I started building the firebox. I was limited to my dimensions because the top and bottom plates are off the mounting plate off of the tank I bought. The middle pieces are from the scrapyard. I paid 10 bucks for a piece 12"x48". It was a quarter so I thought That wa...

This unit is amazing. Only thing wrong is not big enough. Once u cook on green egg u will be hooked.

My tank is 1/4 inch think. How many cut off wheels do u guys think I will go thru. Luckily rural king had them on sale. I bought 10. I hope that is enough

I use almost the same hinge on alot of things, the only difference is the ones I have do not have the grease fitting on them. The best part is, if ya don't get it right the first time, just cut it off and start over. Thank u smoker Tom. I thought I couldn't go wrong with them. They were only 5.25 a...

Has anybody used these hinges. I picked them up at grainger. They are weld on bullet hinges

Thanks smoker Tom. I am glad u guys are helping. I need help with the specs on smoker. The tank is 68 inches long and 24 inches wide. The tank is 1/4 inch thick. Any info would be great

Yes it will be mobile. I will post pic of trailer when I get it. It is a trailer the rental place had to haul 1 yard of ready mix concrete. It is built like a tank. It actually has working surge brakes on it. I will probably take all That off and weld a new tongue on the front. It would look a lot b...

The plate is 3/8" for top and bottom. I have 1/4 inch for everything else.

I am building my first smoker. Glad I found this sight I need help with the specs. I have a thread in smoker design. I am Smokey Indiana

Here is plate off top of tank

The tank specs are 68"x24" What size firebox should I have and should I cut one end off to have flat surface to weld firebox on.

Here is pic without plate on top. I am going to use plate for top and bottom of firebox

I really don't know for sure. Was hoping to get all info needed from u guys. Would like info good or bad about my build. I know it is going to be a reverse flow

Pics of tank

Here is some pics of my tank.

Hello I am new to this site. Hell I am new to building smokers. I hope everybody could share a little knowledge with me