SmokerBuilder.com

wouldn't laying it on a wet rag, and slowly stitching it work OK?

Ok, makes sense to me now.

pulling up an necrothread for one reason.... misinformation is worse than no information. Galvanized metal is only off gassing when temps reach 900*F or so... so using it in a location where temps get higher than that... Like a firebox, or plate at the exit of the firebox... perhaps you want to avoi...

Hello All, The Cylinder is 47in in diameter by 40in long. I have not cut into the cylinder yet but I'm guessing on my ID numbers. Smokingmeat Numbers: 14.59 x 14.59 x .7854 x 39.5 = 6603.87 / 231 = 28.59 Gallons Hi folks. I'm late the the game, but have a question. a 47" diameter tank 40" tall is a...

Big T wrote: If you get them too tall the air can condense and drip moisture back down into the CC.

insulate the stack?

What would you guys recommend. I have access to either pipe size. The pit calculator recommends 41" of chimney for 8" pipe or 26" for 10" pipe. 26" would still clear WC by 12-14"s. The 8" pipe would make the highest point of the pit to ground be 110"s/9' overall.. So which route would you guys go? ...

.....Now the reason I still bring up the offset exhaust in spite of your plan is because I prefer to not use a diffuser. I've been told it takes a lot more charcoal to get to temp with it. Instead I use a "spacer" in the middle of my basket to prevent a hot spot. I think my basket is 18" wide and 9...