Thank you Smokeone!!Smokeone wrote:Ok I'll give it a shot. I would do the seal/flange on the outside. As far as the B/P questions, it usually sits about 5 inches below the grate. The bp should have fall to the drain, usually about an inch. I would use black iron and weld a fitting to the bp and screw the pipe in. Why I don't know, just how I would do it. As far as paint removal, you could use a flap disk on a grinder, but blasting woild be easier.
Note: these are just my .02. The others may have better answers.
Sent from my iPhone using Forum Runner