So the rigged board is what I want? If I get that I’ll probably insulate the bottom was well since half will be leftover.Chromeski wrote:The one posted from lowes looks to be batt not a roof ridged board. I did buy a pack of the ridged stuff from lowes last week. I think I would prefer that for this application.
Lol trust me I wish I hadn’t. If I ever build another one I’m buying a plasma cutter for sure.Dirtytires wrote: ↑December 15th, 2018, 12:12 amMy first thought is you did that semi-circle cut with a cut-off wheel. My second thought is that is pretty darn good cutting!
Looking pretty good from here....keep at it!
Thanks Big T. This is going on a trailer now and not the cart. Changed plans. But I like your suggestion.Big T wrote:Either way will work fine but I prefer to weld the CC and FB together before I mount it to the stand/trailer. I find that it's easier to get a good weld on them if I can flip it over and there's nothing in the way. You could mount it to the stand and then add the FB as long as the stand doesn't make it difficult to access the welds that join the unit together. I usually set the FB flat on the floor and lift the CC into position, I put several good tacks on them and recheck that it didn't move, I then weld as much I as can reach, flip over and weld the bottom.