I have the Forney easy weld 140. I don’t think it’s capable of gas. There’s no gas port to my knowledge anyway. But it’s bell a hell of a little welder so far. Super splattery at first, but after I changed to a diff brand of wire, it dialed in super easily.Dirtytires wrote:Flux wire is horrible! They make tiny "toothbrush" sized wire brushes that might work for you. I have a small air grinder with a 1.5 inch flap wheel that works really good for tight places that my big grinder won't get to.
The minimal cost to convert to shielding gas is worth it just for the aggravation prevention alone! Tank, hose, regulator and a new tip and you are set...tell Santa your wishes!
[emoji1787][emoji1787]thanksSheffSmoker wrote:I'm in the UK, so any link I know will be pointless for you Stateside.
Try a search on "end brush wheel" at some of your HW stores like ACE or Harbor Freight. I even took the time to spell "Harbour" incorrectly too.