Horizontal offset/ reverse flow build

[Frank_Cox]

here's some pics of the tank and how we hung it under the trailer.

hanging the tank with straps to support the bottom of the tank and putting a couple bolts through the flange to prevent the tank from sliding around

another pic of the tank

a pic of the tank from the drain side

drillin out the top of the tank

one hole drilled and one to go

the hub seals are installed and the tank vent is in place

more in a sec

[Frank_Cox]

on to the tank drain and the cooking grate for the grill...

drain fittings installed

closer shot

water hose connection open

3" drain connection open, valve closed

valve open a little

valve open all the way

got the cooking grate done

gonna try to hit it again tomorrow.

[Gizmo]

Good lookin' work on the "Winna - bake - o" trailer -

[pitbull8151]

Thats nice!

[Frank_Cox]

Thanks EK!
Thanks Pitbull!
I think we are goin to work on the enclosure for the freshwater tank later today.

[Tommy Joe]

Frank The pic of you drilling under your trailer looks good untill I saw no eye protection. Thats a good spot to be wearing it .

[Frank_Cox]

DOH!... you got me... actually that's dcman doin the drillin. Those plumbers, I tell you what!

[Tommy Joe]

That explains it, I had a step Dad that was a plummer and I could tell when he had been down in the sewers. He started taking short cuts also, must mess up the grey matter.

[Frank_Cox]

Hahaha, them guys aren't scared of anything!

Sent using Forum Runner. Try it out for Android or iPhone IOS

[Tommy Joe]

At least nothing that runs through a pipe that is!

[The Czar]

My master metal maker isn't paying me enough to wear eye protection.... .....actually come to think of it, I ain't getting paid at all!!

[Frank_Cox]

hahaha,

[The Czar]

hahaha,

.....I love these things.....

[Tom_Heath]

Well then.......I guess when you need a helper on the next sewer clog then you better take Frank with ya. LOL

[The Czar]

.....that will be the day.... ....it will never happen....I think he's scared....

[k.a.m.]

Frank, nice job on the tank fit up and the grate. How do the fittings for the waste water tank attach? I like the idea of putting them where you need them.

[Frank_Cox]

Thanks kam! the tank is made of ABS plastic and so are the fittings. the tank has a female slip hub on it and you glue a male slip flange fitting into it. after that is attached the blade valve fitting has a gasket ring and bolts up to the flange on the other fitting. the outlet is a 90* twist on cap and has a waterhose connection. you can either use a water hose to drain it or a 3" RV sewer drain hose.

[Gizmo]

...all depends on the size of your "floaties"

'course you prolly aren't going to put a disposal in THAT sink anyway...

Hmmm - then again...

I just love overdesigning stuff! - 'specially when it's somebody else's $$$$

[The Czar]

EK....trying to talk him into another waste tank....it won't be very hard!!!!

[Gizmo]

...not after the first one went in so easy....

[Frank_Cox]

well, I just found out that according to health code. a mobil kitchen must have a waste tank 15% larger than the fresh water tank. so since they are both the same size....

[Gizmo]

I wish you luck dealing with the government...

...just sayin' ...

[KILLSWITCH505]

pretty bad a$$ build frank i really dig the jacks on the Santa maria cooker you can bet your butt ill be using that someday

[Gizmo]

never seen "butt" and "jacks" in the same sentence on this site before ... I mean in a clean way ...

[Frank_Cox]

Thanks KillSwitch!