On this^^^ - did you ever reconcile this? Getting to the same point in my build and running into the same question.Chromeski wrote: ↑August 21st, 2018, 2:52 pmIts important to mention my cut list shows some 1 3/4" 14 ga tube for frame that i do not see on the plans. I have not built mine yet and its possible all will make sense once I start building. Either way I recommend looking over the plans a few times before buying materials
Not exactly, I believe they were planning to make the door frame from heavier tube and that upgrade just hadn't made it in to the plans yet. I was just going tip build mine from the 14 ga and call it a day. Don't take my word for it tho Frank is the authority on that stuff. I have not built mine yet because for some reason it's incredibly difficult to get a quote on laser cutting, but that is a whole different story.aakelley wrote: ↑October 2nd, 2018, 5:51 pmOn this^^^ - did you ever reconcile this? Getting to the same point in my build and running into the same question.Chromeski wrote: ↑August 21st, 2018, 2:52 pmIts important to mention my cut list shows some 1 3/4" 14 ga tube for frame that i do not see on the plans. I have not built mine yet and its possible all will make sense once I start building. Either way I recommend looking over the plans a few times before buying materials