DT where is here? Shoot me a pm I need steel for my buildDirtytires wrote:I realize diferent parts of the country have significantly different prices and I may not be reading the cut-sheet correctly. You might, however, check around to see if those are the best prices in your area. I can do 20% better than your discount prices just walking in the door here.
However, looks like you got the material for a great start and can’t wait to see what you turn it in to.
I 2nd this advice. I had to cut out a piece of the frame to get the charcoal chute in. It was fairly easy to weld it back together after but, much easier to leave it out until the chute is in place.ajfoxy wrote:Just a heads up... probably don't weld the top tube by the chute yet. It makes getting the chute/firebox/diffuser assembly a whole lot easier without it. Once the assembly is in place then you can weld the top tube in. Been there, done that...
Cole wrote:Looks nice, clean joints and welds! That thing is big, I added 6" to my Mini and its heavy, the DP is large, be careful and the weight builds and plan for help!
Looking real nice at this stage...hannibalsmith63 wrote:Thanks for the feedback. All are tacked in except for the three pieces that are stated not to be installed yet. Hopefully we are good!
Sent from my iPhone using Tapatalk