Double Pan GF Tubing length

Leukic · Post by **Leukic** » May 24th, 2018, 8:44 pm

I am currently getting materials together for this build but I am wanting a double check on the amount of 2x2by16ga tubing I am needing. I roughly added it up at work last night and I believe i need around 80ft of tubing. Can someone verify this? Also the amount of sheet metal/sheet size did most of yall use.
thanks
Josh

Leukic · Post by **Leukic** » May 24th, 2018, 11:57 pm

Never mind I just found Hannibalsmith metal order sheet in a thread and it makes sense

Dirtytires · Post by **Dirtytires** » May 25th, 2018, 12:00 am

if you need to pay for delivery, order an extra stick. It will save an extra charge when you cut a piece too short and need to start again.

Leukic · Post by **Leukic** » May 25th, 2018, 12:06 am

Dirtytires wrote:if you need to pay for delivery, order an extra stick. It will save an extra charge when you cut a piece too short and need to start again.

I would be hauling it myself but that is a good idea. The metal company is about 30 mins from my house so.

Dirtytires · Post by **Dirtytires** » May 25th, 2018, 12:14 am

About 10 years ago i started buying an extra stick of whatever i was buying for whatever project i was working on. Ive finally got a descent supply on hand and no longer need to run to the supply yard for every project.

Texasbowhunter · Post by **Texasbowhunter** » May 25th, 2018, 2:46 pm

Dirtytires wrote:About 10 years ago i started buying an extra stick of whatever i was buying for whatever project i was working on. Ive finally got a descent supply on hand and no longer need to run to the supply yard for every project.

Good advice to live with

SmokerBuilder.com

Double Pan GF Tubing length

Double Pan GF Tubing length

Re: Double Pan GF Tubing length

Re: Double Pan GF Tubing length

Re: Double Pan GF Tubing length

Re: Double Pan GF Tubing length

Re: Double Pan GF Tubing length