Pulled it at 180° ,put it on the table and put a tarp over it till Showtime.
A little info on the gurney.
It's 1/2" square steel.Not sure of the exact measurements but his door isn't very wide compared to most.his door is 2" inset of the welds on each bell end. I got lucky on my tank mine has only 1 weld line and it's dead center,allowing me to stretch my door to within an inch before the bell starts to curve.Ill dig up a pic of mine.
and theres 2 sheet pans to sit on top to help hold everything.
![Image](https://uploads.tapatalk-cdn.com/20181113/47f9e559f5a76657f09a25fec026e005.jpg)
![Image](https://uploads.tapatalk-cdn.com/20181113/3a80e67278cb6db79c5461b7fb32c522.jpg)
![Image](https://uploads.tapatalk-cdn.com/20181113/3546e2c264c5ca04a7d1efb29170a778.jpg)
![Image](https://uploads.tapatalk-cdn.com/20181113/aec79c287a6fc23920023f512646cdd7.jpg)
![Image](https://uploads.tapatalk-cdn.com/20181113/7055cd54084d5f975df5eb4f4b4fce41.jpg)
![Image](https://uploads.tapatalk-cdn.com/20181113/e5051472e27a4279f2a261003b2555fa.jpg)
![Image](https://uploads.tapatalk-cdn.com/20181113/e2eddf226bffd65f3beb5cb1005ac6d4.jpg)
![Image](https://uploads.tapatalk-cdn.com/20181113/6fc585342b714c3455d1e9f19bdd72ce.jpg)
Sent from my LM-Q710(FGN) using Tapatalk