Aaaaand the final product.
Pulled it at 180° ,put it on the table and put a tarp over it till Showtime.
A little info on the gurney.
It's 1/2" square steel.Not sure of the exact measurements but his door isn't very wide compared to most.his door is 2" inset of the welds on each bell end. I got lucky on my tank mine has only 1 weld line and it's dead center,allowing me to stretch my door to within an inch before the bell starts to curve.Ill dig up a pic of mine.
and theres 2 sheet pans to sit on top to help hold everything.
Sent from my LM-Q710(FGN) using Tapatalk