Yep I'm with you, essentially use the scrap as a guide for the holesaw. The holesaw will be a while for delivery so will go onto other bits!BigPete wrote: ↑February 6th, 2021, 10:10 amYour step bit is trashed at the width you are at. Dull. It’s done.
Here’s a tip to drill that hole you’ve already started once you get your hole saw. It will be hard to finish your existing hole since it’s larger than your pilot hole for the saw. Cut a hole with your hole saw in a piece of scrap. Then clamp or tack the scrap over the hole you’re trying to finish as a guide. It will make finishing that hole so much easier. Use your cutting oil a lot with the hole saw as well. Don’t put too much pressure on it while you cut.
[/quote]
What, no Amazon same day delivery across the pond?