Aye, sprung in almost 3". Had a bit of lumber and a few jacks stretching it back open for a while. Ended up chopping an inch off and rewelding it, so time to redo all the calcs again. Been flat out busy with life so not got the door cut yet.
Sweet, nice it did not take a lot to get it out.hogaboomer wrote: ↑August 16th, 2021, 1:19 pmWell, that pulled in no sweat with the baby come along, and tacked some round bar gussets inside to hold it. Little bit of tweaking with the big crescent and cheater bar and everything is looking good.
That is sweet! Something I would do in a heartbeat. You will need to leave the exposed welds, add rivets along each seam for looks too! Steam punk that baby!