and pretty damn well if I do say so myselfdcman wrote: ......he used a cutting torch? .....
Yeah, you have been a little slow on the draw lately Frank. My pleasure I help where I can.Frank_Cox wrote:
Thanks for helpin out kam! I been real hit and miss lately!
I'm not a pro but what's up?cclark wrote:Where's all the pros at? I need some advice lol
ok thanks a lot kam!k.a.m. wrote:cclark, on a 250 gall. build I bring my top cut line down 6" to 6.5" below 12:00 I have my lower cut 1" below 3:00. This should give you about an 18" tall door.
I hope this helps.