New user needs some design advice

trekinaway · Post by **trekinaway** » December 4th, 2013, 5:00 am

Hello to everyone, I have the plans for the big bulls smokin bbq machine which has a circular cooking chamber Dia 30" x 72 1/2" long. I am in Australia and am having difficulty sourcing a cylinder of this size and was thinking of fabricating a square chamber of 30" x 30" x 60" long (this would maintain the same volumetric size). Can anyone advise if this would be ok or is there a better alternative.
I can't wait to get her built and start bbqing southern style!!!

Gizmo · Post by **Gizmo** » December 4th, 2013, 6:13 am

If you maintain the same volume then you will be fine.

…and WELCOME! Glad to have another one from down under….

Post by **Rodcrafter** » December 4th, 2013, 8:21 am

Yep, and welcome to the fun. I feel your excitement, I just started another one too.

Sent from my 5860E using Tapatalk 2

Rev.Mike · Post by **Rev.Mike** » December 4th, 2013, 11:49 am

dwwantasmoker · Post by **dwwantasmoker** » December 4th, 2013, 1:56 pm

What they said.

If water runs counter clock wise there does smoke flow in reverse

Smokeone · Post by **Smokeone** » December 4th, 2013, 6:25 pm

Post by **Big T** » December 4th, 2013, 7:37 pm

The Czar · Post by **The Czar** » December 4th, 2013, 7:57 pm

Welcome aboard!

Sent from my iPhone using Tapatalk Pro

trekinaway · Post by **trekinaway** » December 4th, 2013, 11:32 pm

Thanks for the advice and the warm welcome. Will try and document my build with lots of pics. Probably won't be till after Christmas but stay tuned!!!

bluecatfish · Post by **bluecatfish** » December 5th, 2013, 4:59 pm

Clover Ridge Smokers · Post by **Clover Ridge Smokers** » December 5th, 2013, 7:31 pm

Welcome

Grabber70Mach · Post by **Grabber70Mach** » December 5th, 2013, 7:45 pm

Welcome

Sent from my VS980 4G using Tapatalk

SmokerBuilder.com