What sorta mechanical opening devise are you going to use? I see this is going to be heavy. You know I don't see anything wrong with heavy, it just becomes too much to do by hand.
Current Smokers: Backyard RF Offset and Hybrid RF Offset trailer rig with Cowboy cooker and fish fryer, always room for more........
Spring loaded pins that will be attached with a cable to the center from each end to a pull style latch to be able to swing out. The support/brace arms are going to have a swivel hinge 1.5" tubing that will slide into a 2" tubing which will swivel also. If it is too heavy for two guys to handle I will improvise a mechanical system to extend them. I have some ideas already. But hope to not have to go that route.
I prefer heavy...
Very nice FC! I like the pin system. The best thing I can mention about your shelf in front of the CC is; try to get 6" below the doors at least. Or what you set on it will always be in the way.
After going back to look at the front of it again, I guess that is what you're planning since it folds up you will still be able to clean your fenders.
Nice work buddy!
Making memories.
Current Smokers: Backyard RF Offset and Hybrid RF Offset trailer rig with Cowboy cooker and fish fryer, always room for more........
Thanks fellas!
Dead-on RC on the fold up! I'm setting it so it will just clear the fender. Not sure what the height will be but I think it's more than 6"s. For the exact reason you mentioned. I want the doors to clear food and adult beverages...
Thank you kindly Sir RC!
The MAN
The MYTH
The LEGEND
RC everyone!!!