Thanks for all the kind words of encouragement!Rodcrafter wrote:Welcome to the crew!
There's also lots of ways to make an RF, vertical, offset, center feed, each has plus and negatives. The vertical will operate more like what you have been using, but the offset will be like a hungry child always requiring attention. But who doesn't like to play with fire and feed hungry kids?
Making memories!
That makes sense, and yes I was talking about the pinwheel on the FB. So plan on 2 4 inch pinwheel. Or should I plan on 2 6inch?Rodcrafter wrote:All the numbers check out fine. The only thing that comes to mind is the part you mentioned about "dampeners" I'm guessing you are talking about air intakes on the FB? If that's right and you are planning on making round pinwheel type like on the website. I see you are making 1- 4" round intake, using a pinwheel you will need 2 that size to get the same number as half the opening is always closed even when it is all the way open. But I like having a intake on at least 2 sides anyway.
Making memories!