My wife would not even hesitate, she would kill me, lolBig T wrote: all ready gathering parts for the next one!
I had the same issue...so I'm going to paint it camouflage to hide all the warpage.Heatermeter builder wrote:I was doing some welding on the door and I think I went a little to fast and may need to start over on it. The sheet metal is warped, or has visible waves in it. Is there anything I can do to minigate it or should I just start over. Both side are not as flat as I would like. I was welding the seems and well I did not stitch to good, I guess lol
I think I'm going to go with some 11 gauge on the door. I already received a quote for some 50x33 pieces and it's not to bad. It will only add about a 100 pounds or so to the door, lol.Cole wrote:When I was talking to Frank he suggested screwing the exterior skin on to prevent warp, not sure if anyone has done this.
I don't think so, you would have to take the FB apart to get to it. But it's pretty thick, and should last a fairly long timeCole wrote:I noticed on the prints that there is some expanded metal between the firebox and cook chamber, is this replaceable after assembly if needed?