Ahh, I did not think about doing that. But, that would still require 15 pieces and I only have enough for the bottim.. I would still need to make an order and might as well get 10 more cutajfoxy wrote:You only need the top bit of the rack holder on the last third or so. That is just to stop the rack from tilting. So if you wanted to save a bit of money you can cut the top one in half and only weld the top and bottom on the first bit.
Went out and took some pictures. I plan on the same rack design on my mini. Like I said probably not easier or cheaper but it slides like butter.Heatermeter builder wrote:Ahh, I did not think about doing that. But, that would still require 15 pieces and I only have enough for the bottim.. I would still need to make an order and might as well get 10 more cutajfoxy wrote:You only need the top bit of the rack holder on the last third or so. That is just to stop the rack from tilting. So if you wanted to save a bit of money you can cut the top one in half and only weld the top and bottom on the first bit.
I will check into this oversite in the plans, Thanks for the heads up.Heatermeter builder wrote:Found another overlooked mistake in the GF plans. The plans Call for 10 1/8- 3/4x3/4 angle iron pieces for the rails to hold the racks. But, when you look at how they are welded and how they are used, you need 20 of them.
I guess you could just use two pieces per rack, then the plans should state that, or they need to be changed to reflect the correct quantity of 20. Now, I had to put another order, my wife is going to kill me, as I told her yesterday, and I quote, "I have all the steel paid for" lol
Thanks, going to use an heatermeter with an RD25 damper. The blower will have up to 28cfm, so its should be plenty.Cole wrote:Looks awesome. What controller and fan u gonna use?