Any issues on the small doors trying to come off without you wanting them to?Rodcrafter wrote:I make swinging doors removable just because it didn't help not to. I mean there isn't a down side to it.
jm2cw
Any issues on the small doors trying to come off without you wanting them to?Rodcrafter wrote:I make swinging doors removable just because it didn't help not to. I mean there isn't a down side to it.
jm2cw
Rodcrafter wrote:The small door on top of the chute I didn't allow to come off just the others.
I put up a forum post over in the Fabrication section. Feel free to go check it out. Welding TableTexasbowhunter wrote:Not to deviate from your Smoker and as others have commented that is a nice table...
What was the width of the plate you used for you surface and the spacing you used between the plates...
Can you include a link to this table design to get some of the questions which will come to mind later
paul
Rofl!!Big T wrote:Good thing you're building mini's or he wouldn't be able to reach the top.
I had ordered a couple sets of casters and none of them fit the plates I had cut for the table. So when I ordered the casters for the Mini I just ordered 4 extra swivels for the welding table.Cole wrote:Its the wheels, too big!