man oh man, that thing looks great! think it looks better everytime I see it lol!Weldun wrote:Cost of a build is really dependent upon many factors in my opinion, I cut all my own materials and didn't utilize an outside laser cutting service . I also was able to treasure hunt a good amount of my materials, in fact the only steel I had to purchase was my sheeting, angle iron and my square tubing. I'm certainly not knocking paying for laser cutting services but that is an added expense. I think if a person is patient and spends some time treasure hunting they can get into one of these with a minimal investment. I'm not sure what your area has to offer but I do know that in my neck of the woods there are scrap yards and salvage yards that can be gold mines for frugal (cheap) people such as myself. If the patience part isn't your strong point you can always build a UDS to get you by while you treasure hunt.
yep, that's right in line. sure makes the build easier! We have been thinking about making a kit for all the chute parts including the transfer tube. anyone think that is a worth wile idea? we would possibly be considerably cheaper than having your local guy do it. we would palletize it and ship it out or it could be picked up at HQ.Heatermeter builder wrote:My material cost were about $1600 all laser cut. That's just the metal. You would still need to get insulation, casters, latches, lots of flap disk and other odds and ends.
A comparible, already made GF, would cost about $6500.
awesome deal! I will get working on it . hope to have something figured out perty quickWeldun wrote:Frank that's an incredible idea, with the small amount of material required for the chute/ firebox/ashbox assembly it's hard to reasonably acquire this material unless you're able to purchase drops from a steel supplier and if you try to utilize hot rolled flat to cut these pieces from you end up with a considerable amount of extra material. I think this kit could make a gravity feed build much easier for folks to take on.
working in it now bro! seriously!!!ajfoxy wrote:Now, on to the kit for "The Mack"... put on a pallet, wrapped and shipped to Australia. One kidney or both?
haha, just watched startrek a minute ago!!!wbegg wrote:Make it so, #1!
That thing looks great!! I have two UDS now and a homebuilt draft control... Want a unit that makes better use of rack space but dont think I want a typical offset grill.Weldun wrote:Cost of a build is really dependent upon many factors in my opinion, I cut all my own materials and didn't utilize an outside laser cutting service . I also was able to treasure hunt a good amount of my materials, in fact the only steel I had to purchase was my sheeting, angle iron and my square tubing. I'm certainly not knocking paying for laser cutting services but that is an added expense. I think if a person is patient and spends some time treasure hunting they can get into one of these with a minimal investment. I'm not sure what your area has to offer but I do know that in my neck of the woods there are scrap yards and salvage yards that can be gold mines for frugal (cheap) people such as myself. If the patience part isn't your strong point you can always build a UDS to get you by while you treasure hunt.