Ever get to that point where tomorrow never comes. Well I got there almost. Life decided to happen, but we got after it good today. One more good day and we should be at paint. Hopefully that day is in the near future.
Now she's coming together nice. Good strong work. One large step towards Q-view...
Learning generally boils down to "Repetition or the avoidance of pain", some people learn by doing, some by watching and some just have to pee on the electric fence.
Whether you think that you can, or that you can't, you are usually right. Henry Ford
Yeah I gotta say. The skinning went allot faster than I anticipated it going. Gonna order a few bar clamps so we can get the door positioned and then we will be all but done.
Question about the CC door. I am going to use 4 bar clamps to hold the door in place while I weld on the bullet hinges. I take it I should wait to install the gasket till after that? do I need to put a spacer in to accommodate for the gasket?
So looking at the thermometer I do not think I can just drill a hole and stick it in as the door is too thick. How have you guys been subverting that issue?
I saw this guy was doing a recess, but I was wondering if there was an easier method.